Dp11eq software, Introduction, Minimum computer requirements – Shure DP11EQ User Manual
Page 8: Software installation
7
English –
DP11EQ SOFTWARE
Introduction
This section describes the Windows-based computer interface software which allows you to
control the Shure DP11EQ . The software controls a dynamics processor which can operate as a
gate, expander, leveler, compressor, limiter, and no overshoot peak limiter. There are parametric
equalizers placed before and after the dynamics processor. In addition, there is a digital delay which
can add up to 1.3 seconds of delay from input to output.
Minimum Computer Requirements
The following are the minimum requirements to run the Shure DP11EQ software.
S
One 486DX 50 MHz IBM*-compatible computer (math coprocessor required)
S
2 MB hard drive space
S
4 MB RAM
S
Windows version 3.1x, or greater
S
1 available RS-232 serial (COM) port
S
One RS-232 cable to connect the COM port of the computer to the DB-9
connector of the DP11EQ
Connecting the DP11EQ to a Computer via the RS-232 (COM) Port
Before connecting the DP11EQ to the computer, determine whether the computer’s RS-232
(COM) port is 9-pin or 25-pin. Use the proper cable (purchased separately). For RS-232 cable
diagrams, see
Appendix C. Cables and Connectors.
С
СС
С
С
СС
С
С
СС
С
С
С
С
СС
С
СС
С
С
С
С
С
С
С
С
С
С
С
С
С
С
С
С
С
С
TO DP11EQ
RS-232 CABLE
(9-PIN MALE)
TO COMPUTER
RS-232 CONNECTOR
1.
Connect the 9-pin plug (male) of the cable to the RS-232 port of the DP11EQ .
2.
Connect the other end of the cable to the RS-232 port of the computer.
Software Installation
1.
Insert the supplied 3.5-in floppy disk into the disk drive of your computer.
2.
For computers running Windows 95 or Windows NT, click on the Start button , then
select
Run...
For computers running Windows 3.1, click on the File heading of the main menu of the
Program Manager, then click on
Run...
3.
In the
Run window, type “a:\setup”, where “a” is the drive containing the disk.
4.
Shure Setup will suggest a destination on your hard disk for the DP11EQ files. Shure
Setup will check the computer hardware to ensure that a coprocessor is present. Setup
will also prompt you for your name and organizational information.
NOTE: Remember to register your software by filling out and mailing the
enclosed registration card, or online via the Shure World Wide Web site
(“http://www.shure.com”). This will ensure that you receive information about
software updates with additional features as they become available.