Icom IC-F610 - Manual (Page 17)

12
2
OPERATION
• Enter #44n ✱ plus station B’s individual code and then
push [#]. This will allow you to cancel the Divert 3rd Party
call.
• Enter #45n and then push [#]. This will allow you to can-
cel the call that diverted to you.
➥In the place of ‘n’, enter 1 for voice, 0 for data, or noth-
ing for both voice and data.
D D SDM (Short Data Message) Call
• Enter ✱2✱ plus data (up to 24 digits in total) via the key-
pad and then push [#]. This will allow you to make a data
call to a predetermined station.
• Enter ✱2✱ plus data via the keypad plus individual code
(up to 24 digits in total) and then push [#]. This will allow
you to make a data call to an individual code station.
D D 5-Digit Routing code calling
Converting a prefix code (3 digits) plus a fleet code (4 dig-
its) to 3 digits allows you to dial a different prefix code and
fleet code by 5 digit dialling.
➥Convertible numbers; 200 to 299, 900 to 999, 20 to 29, 90
to 99.
*Pre-program the prefix and fleet numbers before con-
verting.
• Individual calling with different prefix code.
To call 211 2006 300 from 200 2001 200;
➥Pre-program 22 to prefix code 211 and fleet code 2006
as 5-Digit Routing code. Enter 22300# to start the call.
D D Cancellation of calling
Enter ✱ and then push [#]. This will allow you to cancel the
current call.
➥This will allow you to end the communication or cancel
the current call.
D D Cancellation of Input
When you are entering data via the keypad, push [ ]/[ ].
This will delete the data starting with the last character/digit
entered, allowing you to restart entering the data again.
Push [Clear] to cancel the inputting and return to the wait-
ing mode.
‘ ‘ Special calling via the keypad
D D ReDial
Enter ## via the keypad. This will allow you to redial the
last number called.
D D Short Dialling
Enter # followed by the memory location (1 to 9). This
allows you to automatically dial a commonly used number
from memory 1 to 9 by pushing [
]/[ ].
IC-F610_MPT-2.qxd 05.5.10 1:00 PM Page 17 (1,1)