Icom IC-F610 User Manual
Page 16
11
2
OPERATION
D
D Emergency Call
• Enter
✱9✱ plus an individual code or a group code and
then push [#]. The emergency call will be started.
‘Selectable Emergency Function; Disable*’
➥Enter ✱9, then push [#]. The pre-programmed
‘Emergency Number’ used for the emergency call.
‘Selectable Emergency Function; Enable*’
➥Enter ✱9, then push [#]. The current ‘Dial Number’
selected via [
]/[
] used for the emergency call.
- If the system is busy (no channel is available), a chan-
nel is forcibly made available allowing you to establish
the communication.
‘
Selectable Emergency Function’ can be set with the cloning software
(p. 28).
D
D System Wide Call
• Entering
✱1981# will allow you to make a priority voice
call.
• Entering
✱1982# will allow you to make a voice call.
• Entering
✱1987# will allow you to make a standard voice
call.
➥Each of the above calls is used to call all the mobile sta-
tions that are waiting on the system.
D
D PSTN Call
Enter 0 plus a telephone number (8 digits or more) and
then push [#]. The PSTN call will be started.
D
D PABX Call
Enter 0 plus a telephone number (5 to 7 digits) and then
push [#]. The PABX call will be started.
D
D Divert Own Call
• Enter
✱41n✱ plus the individual code of the station you
want to divert your own call to, and then push [#].
This will allow you to divert your own call to the specified
station.
➥In the place of ‘n’, enter 1 for voice, 0 for data, or noth-
ing for both voice and data.
• Enter #41n
✱, then push [#] to cancel the diversion.Or
enter #45n# to cancel the above diversion on the station
you want to divert your own call to.
D
D Divert 3rd Party Call
• Enter
✱44n✱ plus Station B’s individual code plus ✱ plus
Station A’s individual code (destination), and then push
[#]. Station B’s call will be diverted to Station A.
➥In the place of ‘n’, enter 1 for voice, 0 for data, or noth-
ing for both voice and data.
• Enter #44n
✱ plus station B’s individual code, and then
push [#] to cancel this diverting.
D
D Cancellation of Divert
• Enter #41n and then push [#]. This will allow you to can-
cel the Divert Own call.
IC-F610_MPT-2.qxd 05.5.10 1:00 PM Page 16 (1,1)