Icom IC-F610 User Manual
Page 13
8
2
OPERATION
t A warning sound will be emitted 10 seconds before the
communication timer reaches the limit. When the limit
has been reached, the communication will be discon-
nected automatically.
y Push [Clear] to manually end the communication.
D
D Making a Status Call
A status message may be sent to the dispatcher or a
remote station having an individual code. (No status mes-
sage can be sent to any station using a group code.)
•Sending a status message to a station having an individual
code.
q Display an individual code by pushing [
]/[
].
w Press the Status Up [
∫]/Down [√] to enter the status
code select mode.
➥ Select the desired message from a total of 32 differ-
ent status messages having code No. 0 through 31.
➥ Status code 0 means “Call Back Request” -- Please
call back, and status code 31 “Previous Request
Cancel” -- Cancels the call. These status codes are
commonly used by all systems.
e Press [PTT], the status message will be sent to the sta-
tion having the selected individual code.
r When the status message has been successfully sent
out, ‘OK’ appears on the display.
D
D Sending a status message to the Despatcher
q Enter the Despatcher mode by pushing the [Despatcher ].
w Press [Despatcher] again. Now you are ready to select
a status code.
➥ If the direct call to the despatcher is selected, you
cannot use status code select condition.
e Push [∫]/[√] to select the desired status message.
➥ Select the desired message from a total of 32 differ-
ent status messages having code No. 0 through 31.
➥ Status code 0 means “Call Back Request” -- Please
call back, and status code 31 “Previous Request
Cancel” -- Cancels the call. These status codes are
commonly used by all systems.
PERSONAL 1
STATUS 01
DESPATCHER
STATUS 01
IC-F610_MPT-2.qxd 05.5.10 1:00 PM Page 13 (1,1)