Ingersoll-Rand NIRVANA IRN75-160K-2S - Manual (Page 4)

IRN37 - 160K - CC & IRN50 - 200H -CC & IRN75 - 160K - 2S & IRN100 - 200H - 2S & IRN 250 - 300H - 2S
http://air.irco.com
2
2.0 FOREWORD
Machine models represented in this manual may be
used in various locations worldwide. Machines sold and
shipped into European community countries requiresthat
the machine display the EC Mark and conform tovarious
directives. In such cases, the design specification of
this machine has been certified ascomplying with EC
directives. Any modification to any part is absolutely
prohibited and would result in the CEcertification and
marking being rendered invalid.
The contents of this manual are considered to be
proprietary and confidential to Ingersoll Rand and should
not be reproduced without the prior written permission
of Ingersoll Rand.
Nothing contained in this document is
intended to extend any promise, warranty or
representation,expressed or implied, regarding the
Ingersoll Rand products described herein. Any such
warranties or other terms and conditions of sale of
products shall be in accordance with the standard terms
and conditions of sale for such products, which are
available upon request.
This manual contains instructions and technical
data to cover all routine operation and scheduled
maintenance tasks by operation and maintenance staff.
Majoroverhauls are outside the scope of this manual
and should be referred to an authorized
Ingersoll Rand service department.
All components, accessories, pipes and connectors added
to the compressed air system should be:
of good quality, procured from a reputable manufac-
turer and, wherever possible, be of a type approved
by Ingersoll Rand.
clearly rated for a pressure at least equal to the ma-
chine maximum allowable working pressure.
compatible with the compressor lubricant/coolant.
accompanied with instructions for safe
installation,operation and maintenance.
Ingersoll Rand reserves the right to make changes and
improvements to products without notice and without
incurring any obligation to make such changes or add
such improvements to products sold previously.
•
•
•
•
Details of approved equipment are available from Ingersoll
Rand Service departments.
This machine has been designed and supplied for
use only in the following specified conditions and
applications:
Compression of normal ambient air containing no
known or detectable additional gases, vapors or
particles
Operation within the ambient temperature range
specified in the GENERAL INFORMATION section of
this manual.
IF IN DOUBT CONSULT SUPERVISION.
The company accepts no responsibility for errors in
translation of this manual from the original English
version.
The design of this Compressor package and certain
features within it are covered by patents held by
Ingersoll Rand and patents pending
SSR ULTRA COOLANT is a registered trademark of
Ingersoll Rand Company USA.
INTELLISYS is a registered trademark of Ingersoll Rand
Company USA.
HPM™, HYBRID PERMANENT MAGNET™ and HPM
Logo are trade marks registered by MOTEURS LE-ROY-
SOMER
© COPYRIGHT 2007
INGERSOLL RAND COMPANY
•
•