Ingersoll-Rand NIRVANA IRN75-160K-2S - Manual (Page 20)

IRN37 - 160K - CC & IRN50 - 200H -CC & IRN75 - 160K - 2S & IRN100 - 200H - 2S & IRN 250 - 300H - 2S
http://air.irco.com
1
6.0 RECEIPT / HANDLING
6.1 RECEIPT
When you receive the compressor please inspect it closely. Any indication of careless handling by the carrier should be
noted on the delivery receipt especially if the compressor will not be immediately unpacked. Obtaining the deIivery
persons signed agreement to any noted damages will facilitate any future insurance claims.
IMPORTANT
READ THIS
LOST OR DAMAGED GOODS
THOROUGHLY INSPECT THIS SHIPMENT IMMEDIATELY UPON ARRIVAL
OUR RESPONSIBILITY FOR THIS SHIPMENT CEASED WHEN THE CARRIER SIGNED
BILL OF LADING
If goods are received short or in damaged condition, it is important that you notify the carrier and insist on a
notation of the loss or damage across the face of the freight bill. Otherwise no claim can be enforced against the
transportation company.
If concealed loss or damage is discovered, notify your carrier at once and request an inspection. This is absolutely
necessary. Unless you do this the carrier will not entertain any claim for loss or damage. The agent will make an
inspection and grant a concealed damage notation. If you give the transportation company a clear receipt for
goods that have been damaged or lost in transit, you do so at your own risk and expense.
WE, AT lR, ARE WILLING TO ASSIST YOU IN EVERY POSSIBLE MANNER TO COLLECT CLAIMS FOR LOSS
OR DAMAGE, BUT THE WILLINGNESS ON OUR PART DOES NOT MAKE US RESPONSIBLE FOR
COLLECTION OF CLAIMS OR REPLACEMENT OF MATERIAL. THE ACTUAL FILING AND PROCESSING OF
THE CLAIM IS YOUR RESPONSIBILITY.
Ingersoll Rand Company
6.2 UNPACKING AND HANDLING
The compressor will normally be delivered with a polyethylene or other cover. If a knife has to be used to remove this
cover, ensure that the exterior paintwork of the compressor is not damaged.
Incorporated within the base of the compressor are slots to enable a fork lift truck to move the machine. Ensure truck
forks are fully engaged on both sides. Alternatively a special lifting frame can be utilized to enable a crane or hoist to
move the compressor. Use only marked lifting points.
Once the packaging and pallet are discarded and the unit is in its final position, remove the transit brackets from the
resilient mounts and store for future use or discard.
On N75−160 units remove the screw in the base and slide the separator tank service bracket into the upper position on
the slots and tighten screws.