Intellinet Network Solutions 509077 - Manual (Page 3)

Thank you for purchasing the INTellINeT NeTWoRK SolUTIoNS ™ 1-Port MFP
USB Wireless Print Server, Model 509077. Unlike many MFP (multi-function printing)
servers, it can communicate with your all-in-one printer as if it were connected
directly to your computer, allowing all users to share print, scan, card reader and
fax functionalities over the network. You can even monitor important information
such as ink levels.
The 1-Port MFP USB Wireless Print Server features Ieee 802.11g/b wireless lAN
connectivity (up to 54 Mbps data transfer rate), an ethernet network port (10/100
Mbps ethernet) and a USB 2.0/1.1 port, and can be connected to your 802.11g/b
wireless network or wired network.
The easy-to-follow instructions in this user manual help make setup and operation
relatively simple. NOTE: Some screen images have been modified to fit the format
of this manual.
SaFety & coMPliance StateMentS
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of FCC (Federal Communication Commission)
Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio technician for help.
operation is also subject to the following two conditions: 1) This device may not
cause harmful interference; and 2) this device must accept any interference
received, including interference that may cause undesired operation.
FCC W
arning
Any changes or modifications not expressly approved by the party responsible for
compliance could void the authority to operate equipment.
FCC r
adiation
E
xposurE
s
tatEmEnt
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. In order to avoid the possibility of exceeding the FCC
radio frequency exposure limits, human proximity to the antenna shall not be less
than 20 cm (8 inches) during normal operation. The antenna(s) used for this
transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
r
adio
F
rEquEnCy
i
ntErFErEnCE
r
EquirEmEnts
This device is restricted to indoor use due to its operation in the 2.4 GHz
frequency range. The FCC requires this product to be used indoors in the 2.4 GHz
SAFETY & COMPLIANCE