IntraServer Technology ITI-90-100250 - Manual (Page 65)

Page 65 of 83
ITHPS: ddi_dma_buf_bind_handle: DDI_DMA_INUSE impossible
ITHPS: ddi_dma_buf_bind_handle: xxh unknown/impossible
ITHPS: ddi_dma_unbind_handle: failed
The operating system failed to respond to the named routine in a
known manner. This is a fatal error that is not recoverable. Please
report this error to technical support.
ITHPS: No KeyROM found. Hardware contains no valid license
The adapter is not a valid IntraServer adapter licensed for use with
Solaris.
ITHPS: Device in a slave-only slot and is unusable
ITHPS: Hi-level interrupts not supported
The adapter is in a slot that can not be used with this driver. Please
try moving the adapter to a different PCI slot.
ITHPS: Failed to attach. This adapter will not be installed.
Because of one of the previous two errors, this adapter could not be
"attached" to the I/O subsystem and will not be accessable. See
the previous error message and solve that problem.
ITHPS: Unable to obtain soft state structure
The driver was unable to initialize a required data structure and
therefore did not load. Please call technical support.
ITHPS: Failed to attach interrupt handler
The driver was unable to initialize the interrupt handler as required.
Please call technical support.
ITHPS: The adapter is malfunctioning
ITHPS: The adapter is malfunctioning or is of an unknown type
The driver is not able to communicate with the hardware. You may
need to update your driver or your hardware.
ITHPS: Failed to create minor node required for DMI interface
The driver was unable to create an entry point for the DMI device
driver. If you are not using the DMI device driver then you may
safely ignore this message.
ITHPS: Could not attach to the SCSI subsystem