IntraServer Technology ITI-90-100250 - Manual (Page 34)

Page 34 of 83
Cabling Internal Devices
Be certain to use the IntraServer LVD differential cable and the LVD/SE 68-
pin connector to connect all your internal LVD peripherals. The cable has a
built in terminator at the drive end. The ITI-8000 Series adapter will
terminate the controller end.
Figure 9: Internal Ultra2/LVD Devices Using ITI-8241C-R Rear I/O
This example shows correct cabling of internal LVD devices to SCSI bus B
of the ITI-8241C-R Rear I/O module.
Note: In this configuration external drives connected to the bus B rear I/O
connector are not supported.
Ultra2 SCSI LVD/SE
Internal Connector
Ultra2 SCSI LVD/SE
Terminator
Ultra2 SCSI LVD/SE
Internal Cable
Ultra2 SCSI LVD Internal
Devices
T
Ultra2 Wide SCSI
LVD/SE Internal
Connector