IntraServer Technology ITI-90-100250 - Manual (Page 58)

Page 58 of 83
Configuring the Driver Software
Beginning with the Solaris 2.6 Hardware: 5/98 release the Solaris qfe
software driver that is used by the ITI-8241C-S is bundled with the Solaris
operating system.
Note: For information on how to obtain the latest patches and patch
revisions, visit the SunSolve

website at http://sunsolve.sun.com ,
SunService

or you local reseller.
Configuring Host Files
After installing the IntraServer ITI-8241C-S CompactPCI
®
Adapter, you
must create a hostname.qfe file for each Ethernet interface. You must
also assign an IP address and a hostname for each Ethernet interface in the
/etc/hosts file.
Installing the software for the ITI-8241C-S
qfe adapter entry
Create an /etc/hostname.qfe0 file. The number 0 following qfe represents the
first instance of the qfe device. Use channel qfe1 for a second Ethernet
channel and so on.
•
Do not create /etc/hostname.qfe files for the IntraServer qfe
channels (if any) you do not plan to use. The /etc/hostname.qfe
file must contain the hostname for the appropriate network interface.
•
The hostname should have an IP address and should be entered in the
/etc/hosts file.
•
The hostname should be different from any hostname of any other
interface, for example: /etc/hostname.qfe0 and /etc/hostname.qfe1
cannot share the same hostname.
•
The following is an example of the /etc/hostname.qfe files
required for a machine called intra that will be known as intra-1 and
intra-2 on the networks connected to the qfe0 and qfe1 Ethernet
interfaces.
intra # cat /etc/hostname.qfe0
intra-1
intra # cat /etc/hostname.qfe1
intra-2
intra # cat /etc/hostname.qfe2
intra-3