Intermec PB50 User Manual
Page 53
Chapter 3 — Troubleshooting and Maintaining the PB50
PB50 Mobile Label and Receipt Printer User’s Guide
43
Possible PB50 Error Icons and Messages
Error Icon Error Message
Description
Pause
The print job is paused.
Paper out (IPL)
Out of Paper
(Fingerprint)
The printer is out of paper. Load a new roll of
media. For help, see
Testfeed not
done
The printer did not perform a testfeed before
it printed out test labels. It is important to
perform a testfeed because it calibrates the
sensor.
To perform a testfeed:
•
In Fingerprint and ESC/P, press the
Feed
button for more than 2 seconds.
•
In IPL, open and close the media door and
then press the
Feed button.
‘
Printhead hot
The printhead is overheated and needs to
cool down. In IPL, wait for printing to resume
automatically. In Fingerprint and ESC/P,
your print job is lost.
Upgrading
The printer is loading new firmware.
LSS too high,
LSS too low
These errors can occur when you run a test
feed without any media installed, or if you
have incorrect media settings.
Load the printer with media (see
), run Test mode (see
), and select
the appropriate media type.
IP configuration
error
The printer is trying to acquire an IP address
from the network. Wait for the printer to
complete the task before taking any action.
IP link error
No network connection.