Intermec PB50 - Manual (Page 42)

Chapter 2 — Configuring the PB50
32 PB50 Mobile Label and Receipt Printer User’s Guide
To configure the printer to use WPA-PSK or WPA2-PSK mode
1 Send the following commands to login as an admin and set the
SSID:
.x,su -p pass admin
ws,SSID,xxxxx
where xxxxx can be from 0 to 32 alphanumeric characters.
2 Send one of the following commands to turn on WPA or WPA2
authentication. Send the WPA-PSK or WPA2-PSK command to set
a pre-shared key:
ws,WPA,ON
ws,WPA2,ON
ws,WPA_PSK, xxxxxxxxxx
where xxxxxxxxxx is a value between 8 and 64 characters.
3 Send the following command to activate the settings:
ws,ACTIVE,1
To configure the PB50 to use WPA or WPA2 Enterprise mode
1 Send the following commands to login as an admin and set the
SSID:
.x,su -p pass admin
ws,SSID,xxxxx
where xxxxx can be from 0 to 32 alphanumeric characters.
2 Send one of the following commands to enable WPA-802.1x or
WPA2-802.1x authentication. You should also send the WPA_PSK
command that does not contain a value:
ws,WPA,ON
ws,WPA2,ON
ws,WPA_PSK,
3 Send these commands to configure the EAP_TYPE:
ws,EAP_TYPE,xxxx
where xxxx can be OFF, LEAP, PEAP, or TTLS.
ws,.EAP_USER,xxxx
ws,.EAP_PASS,xxxx
Note: The default password for logging in as an admin is “pass.” If
you have changed the password, you will need to use your password
instead of “pass.”