Configuring wireless printing using fingerprint – Intermec PB50 User Manual
Page 43
Chapter 2 — Configuring the PB50
PB50 Mobile Label and Receipt Printer User’s Guide
33
where xxxx is the unique username and the unique password for
this protocol.
4
If you are using TTLS, you may need to send this command to set
the TTLS outer name:
xxxx
where xxxx is the outer name.
5
If you are using certificates for validation, here are some
commands you may need to use.
•
Send the following commands to set a certificate and enable
validation:
where c:/testCA.pfx is the location and name of the certificate
and export is the passphrase.
•
Send the following commands to set a common name for
server 1 and server 2:
where xxxxxxxxxx can be a value from 0 to 64 characters.
•
Send the following command to make sure your values match
those used by the access point:
All variables are returned with the exception of EAP_PASS
which always returns “****” if configured and CA_CERT
which transmits the name of the last certificate authority
successfully installed. An additional read-only variable for the
supplicant state, called STATE, is also returned.
•
You may need to send the following command several times for
the wireless station to connect:
Configuring Wireless Printing Using Fingerprint
Use the following procedures to configure your PB50 with
Fingerprint for wireless printing.