To load media for self-strip – Intermec PB50 User Manual
Page 24
Chapter 1 — Using the PB50 Mobile Label and Receipt Printer
14
PB50 Mobile Label and Receipt Printer User’s Guide
To load media for self-strip printing
1
Complete Steps 1 through 4 in the previous procedure.
2
Open the self-strip door in the media cover.
3
Remove a label from the roll of media so that you are left with
several inches of label liner.
4
Feed the label liner over the self-strip bar and out the back of the
self-strip door.
5
Close the media cover until it latches and press down on the self-
strip door to make sure it locks.
6
Pull on the liner to tighten it and ensure a good self strip.
Self-strip door
Self-strip bar