Stovax STUDIO 8700CFCHEC - Manual (Page 5)

5
USER INSTRUCTIONS
Turning the Studio Off
• Press the Off button to extinguish the pilot
2.3 TEMP MODE
The display shows the current room temperature.
To increase or decrease the fire’s output:
• Press the SET button to select either the DAY TEMP
or the NIGHT TEMP mode by briefly pressing the
SET button
• Hold the SET button until the TEMP display flashes and
then let go
• Set the desired temperature with the UP and DOWN
arrows. (Minimum temperature 5C, maximum 30C or
fahrenheit)
• Press the OFF button to stop the display flashing or wait
to return to TEMP mode.
NOTE: If you set a temperature that is beneath the
current room temperature, the fire automatically
switches to OFF.
NOTE: If you would like the Night temperature control to
turn off then decrease the temperature until [---] is
displayed.
2.4 TIMER MODE
There are two programmable settings you can make over a
24 hour period, P1 and P2
P1 + = Start Timed Setting 1
P1 + = End of Timed Setting 1
P2 + = Start Timed Setting 2
P2 + = End of Timed Setting 2
2.4.1 P1 - Program 1 for a Timed Setting
• Press the SET button until the TIMER mode is displayed
• Hold the SET button. The displays flashes the current
time for P1. While the time displayed is flashing you can
alter the hours and minutes set .
To set the time your fire first lights, change the Start Timed
Setting for P1 .
• Press the UP arrow to alter the hour
• Press the DOWN arrow to alter the minutes
in 10 minute increments
• Press SET again to move to the End of Timed Setting,
P1. The display shows the current setting for P1
This is the time your Studio first shuts down:
• Press the UP arrow to alter the hour
• Press the DOWN arrow to alter the minutes
2.4.2 P2 - Program 2 for a Timed Setting
Use the same steps outlined in 2.4.1 to change the setting
for P2.
If you have already set P1 and want to alter the setting for
P2 only:
• Press the SET button until TIMER mode is displayed
• Hold the SET button until the display flashes the
current time for P1
• Press the SET button again to scroll past the settings for
P1 and P1
With the time still flashing:
• Press the UP arrow to alter the hour
• Press the DOWN arrow to alter the minutes
Once all four times are set press the OFF button or simply
wait to complete programming.
2.5 LOW BATTERY
“BATT” is displayed on the remote when its batteries need
replacement.
2.6 SETTING THE TIME
• Simultaneously press the up and down arrow buttons
• Press the up arrow to set the hour and the down arrow
to set the minutes
• Press OFF to return to the manual mode or simply wait
2.7 SETTING THE °C/24 HOUR OR °F/12 HOUR CLOCk
• Press OFF and the down arrow until the display changes
from °C/24 hour clock to °F/12 hour clock and vice
versa.
If the remote is removed, lost or damaged, signals
transmitted to the receiver cease. Your fire will go to
standby (pilot) mode after 6 hours.
2B TOUCH PAD CONTROL
2
AR1885
• Press the ON-OFF button to light the appliance, (up to
30 seconds)
• Press the UP button to increase the flame height
• Press the DOWN button to decrease the flame height. At
the lowest point it goes to ‘standby mode’, (only pilot
lit)
• Press the ON-OFF button to turn the appliance off