Stovax STUDIO 8700CFCHEC - Manual (Page 20)

20
5.2 With the back panel held in place:
• Place the bottom panel at the base of the fire
• Slide the side panels into position
34
AR1865
5.3 To fit the window frame:
• Keep the frame in the upright position with the locks
uppermost
• Offer the frame to the foot of the opening
• Slide the frame to the right to locate the right hinge pin
35
AR1863
5.4 • Manoeuvre the frame up towards the left side to locate
the left hinge pin
• Slide onto the hinge with a right movement
• Secure in place with a spring clip at the right hinge pin,
Diagram 36
INSTALLATION INSTRUCTIONS
INSTALLATION
BOTH METHOD 1 OR 2 - MASONRY INSTALLATION
4.10 • Remove the compression elbow from the appliance and
connect it to the gas supply pipe
As the loose box is fitted into the main appliance:
• Pass the elbow and supply pipe through the silicone
panel on the left side
• Engage the rear of the box onto the three studs on the
rear of the appliance and lower the front edge
• Replace the three wing nuts and seven screws
• Replace the rear loose panel
• Ensure the lower edge engages into the tapered brackets
• PURGE THE SUPPLY PIPE. This is essential to expel any
debris that may block the gas controls
• Connect the elbow to the appliance inlet pipe, Diagram
33
33
AR1963
4.11 • Connect a suitable pressure gauge to the test point
located on the inlet fitting
• Turn on the gas
The burner must be temporarily fitted whilst completing this
procedure
• Light the appliance and check for leaks
• Turn the appliance to maximum and check that the
supply pressure is as stated on the data badge
• Turn off the gas and replace the test point screw
• Turn the gas back on and check the test point for leaks
• Replace the splitter plate and burner
5. ASSEMBLING THE APPLIANCE
5.1 • Add the pebbles making sure they are flattened so they
are level with the rim of the tray
TAKE CARE NOT TO SPILL PEBBLES INTO THE PILOT
AREA
ONLY PEBBLES SUPPLIED BY GAZCO CAN BE USED IN
THIS FIRE
5.2 With the back panel held in place:
• Place the bottom panel at the base of the fire
• Slide the side panels into position