Stovax STUDIO 8700CFCHEC - Manual (Page 27)

7. MAIN CONTROL ASSEMBLY
7.1 To access the main control assembly, first remove:
• the decorative Steel frame (if fitted)
• window frame
• enamelled panels
• main burner
• splitter plate
7.2 To remove the splitter plater:
• Loosen the fixing screws (one each side)
• Lift the front of the plate off the screws
• Pull forward and upwards, Diagram 9
9
AR1966
All components can be replaced without removing the
control assembly.
8. PILOT UNIT ASSEMBLY
8.1 • Remove the screw retaining the pilot cover, Diagram 10
10
AR1963
• Cut the cable tie retaining the vida flex sleeve and
disconnect the ignition lead from the electrode
27
11
AR0097
13mm
4.0mm
• Undo the pilot pipe and thermocouple
• Remove the two fixing screws and retain the vida flex
sleeve which is needed for the replacement
• Replace in reverse order
• Ensure the thermocouple and ignition lead are threaded
through the vida flex and secured with a cable tie
There is a cut out in the pilot shroud to hold the vida flex.
• Check for gas leaks
9. IGNITION LEAD
9.1 • Cut the cable tie securing the vida flex and disconnect
the ignition lead from the electrode
• Pull the lead through the vida flex
• Cut the remaining cable tie and disconnect the lead from
the control box, Diagram 12
12
AR1963
• Replace in reverse order
• Ensure the lead is passed through the vida flex, secured
with a cable tie and the red insulated end is attached to the
electrode
NOTE: DO NOT ROUTE THE IGNITION LEAD IN THE
VICINITY OF THE ANTENNA ON THE CONTROL BOX.
THIS DAMAGES THE COMPONENTS.
SERVICING INSTRUCTIONS
REPLACING PARTS