Stovax STUDIO 8700CFCHEC - Manual (Page 19)

19
INSTALLATION INSTRUCTIONS
INSTALLATION
• Feed the wires for the remote touch pad through the
grommet in the left side of the loose box
The wires are then fed inside the firebox and routed
through the available access
• Replace the loose box inside the main firebox ensuring
the wires are not trapped
• Replace the three wing nuts and seven screws
• Connect the gas supply and check for leaks
• Replace the rear panel ensuring the bottom edge locates
in the tapered brackets, Diagram 29
29
AR1968
NOTE: To check gas pressure refer to paragraph 4.11
• Replace the splitter plate
• Locate the rear two tabs into the rear panel
• Engage the two side slots over the screws and secure,
Diagram 30
30
To replace the burner:
• Locate the left-hand side into the burner bracket
• Lower the right-hand side to engage the injector onto the
venturi and also the pilot into the aperture in the burner
skin
• Push the burner to the right and engage the burner into
the slot in the bracket
• Replace the fixing screw, Diagram 31
31
AR1965
To replace the doors and panels, refer to Replacing Parts,
Section 3 and 5
4.9 METHOD 2 - NO FRAME
The front of the chimney breast has to be studded and
boarded to allow the edge kit to be fitted.
For this cool-wall Edge installation, the convected heat of
the fire is channelled into the cavity between the existing
chimney and the false wall, then vented at the top. The
vent should have a minimum open area of 200mm.
• Proceed as described in Section 4.1 to 4.8, but do not fit
the frame brackets
You have now removed the box from the appliance and
should use the following:
• Fit the edge kit to the two sides and lower edge using the
screws and rawl plugs provided, Diagram 32
32
AR1912
• Stud the face of the chimney breast using the method
described in Section 3.3, Diagrams 14, 15.
DO NOT FIx ANY HORIZONTAL STUD WORK ABOvE
THE APPLIANCE AS THIS WILL PREvENT THE
CONvECTED AIR ESCAPING THROUGH THE vENTS
• Fit the non-combustible board and the plasterboard as
described in Section 3.3
• Apply plaster skim to the front of the chimney breast