Stovax STUDIO 8700CFCHEC - Manual (Page 15)

15
INSTALLATION INSTRUCTIONS
INSTALLATION
7
AR1903
• Fit the supplied top support bar into the stud work at the
correct height, Diagram 8, because no combustible material
can be used above the fire
8
AR1904
NOTE: If a frame is to be fitted, attach the brackets before
installing the appliance.
• Attach the 4 frame fixing brackets to the fire, Diagram 9
• Fix foam seal to the outer flange of the fire
9
AR1913
• Position the fire
• Fit non-combustible board to the stud work around the
fire This should extend a minimum of 400mm above the
appliance and at least 50mm to the sides of the appliance
(from the outer box, not the flanges).
For non-combustible area see Diagram 2b.
The remaining area can be finished using plasterboard:
• Apply a plaster finish to the front of the chimney breast
• Secure the fire back to the stud work using four screws
through flange, bracket, support bar
• Decide on the position for the wall box containing the
batteries and wall switch
• Connect the wire from the fire to the battery pack,
Diagram 10
10
AR1920
• Connect the wire from the fire to the touch pad/
connector, Diagram 11
11
AR1919
• Correctly position the four new AA size batteries
• Re-assemble the battery holder as shown in Diagram 12
• Ensure the touch pad cable is tucked to the left on fitting
the wall plate back onto the wall
12
AR1905
• Secure the wall plate with the touch pad attached to the
wall box, Diagram 13