Jenn-Air 720-0063-LP Instruction Manuals and User Guides
We have 1 Instruction Manual and User Guide for 720-0063-LP Jenn-Air
Manuals 
| Recognized languages: | English |
|---|---|
| Pages: | 28 |
| Size: | 2.11 MB |
Show table of contents
Document Outline
- COVER PAGE-Revised.doc
- Table of content-Revised.doc
- PAGE 01.doc
- PAGE 02.doc
- PAGE 03-Revised.doc
- PAGE 04-Revised.doc
- PAGE 05-Revised.doc
- PAGE 06-Revised.doc
- PAGE 07-Revised.doc
- PAGE 08-Revised.doc
- PAGE 09.doc
- PAGE 10 12-Revised.doc
- LP Gas Cylinder Requirements (20lb. Cylinder)
- LP GAS HOOK-UP:
- GENERAL
- ALWAYS CHECK FOR LEAKS AFTER EVERY LP TANK CHANGE
- Check all gas supply fittings for leaks before each use. It is handy to keep a spray bottle of soapy water near the shut-off valve of the gas supply line. Spray all the fittings. Bubbles indicate leaks.
- Disconnected L.P. cylinders must have threaded valve plugs tightly installed, and must not be stored in a building, garage or any other enclosed area.
- The gas must be turned off at the supply cylinder when the unit is not in use.
- If the appliance is stored indoors the cylinder must be disconnected and removed from the appliance. Cylinders must be stored outdoors in a well-ventilated area out of the reach of children.
- ALWAYS CHECK FOR LEAKS AFTER EVERY LP TANK CHANGE
- PAGE 13-Revised.doc
- General use of the grill and rotisserie
- DO NOT LEAVE THE GRILL UNATTENDED WHILE COOKING.
- CAUTION: REMOVE THE WARMING RACK WHEN USING THE ROTISSERIE BURNER. THE HIGH HEAT COMING FROM THE BURNER MAY CAUSE THE WARMING RACK TO BEND.
- WARNING
- ELECTRICAL GROUNDING INSTRUCTIONS. This appliance (rotisserie motor) is equipped with a plug and should be plugged directly into a properly grounded receptacle. DO NOT cut or remove the grounding prong from this plug.
- Keep the rotisserie motor electric cord away from the heated surfaces of the grill. When not in use remove and store the motor in a dry location.
- PAGE 14-Revised.doc
- PAGE 15.doc
- TO MATCH LIGHT THE GRILL
- If you have already attempted to light the burner with the igniter, allow 5 minutes for any accumulated gas to dissipate. Keep your face and hands as far away from the grill as possible. Insert a lit extended match or lighter through the cooking grids to the burner. Press the control knob and rotate left to the HI setting, continue to press the knob until the burner ignites. Burner should light immediately; quickly remove your hand to avoid getting burned. If the burner does not light in 4 seconds turn the knob off, wait 5 minutes and try again.
- PAGE 16.doc
- PAGE 17--Revised.doc
- PAGE 18-Revised.doc
- PAGE 19-Revised.doc
- PAGE 20-Revised.doc
- PAGE 21~23-Revised.doc
- PAGE 24~ 25-Revised.doc
- Page 26.doc
- 720-0063LP.pdf
- 1.pdf
- 2.pdf
- 3.pdf