Hypertherm Powermax30 AIR Service Manual Instruction Manuals and User Guides
We have 1 Instruction Manual and User Guide for Powermax30 AIR Service Manual Hypertherm
Manuals 
| Recognized languages: | English |
|---|---|
| Pages: | 223 |
| Size: | 11.91 MB |
Show table of contents
Document Outline
- Contents
- Electromagnetic Compatibility (EMC)
- Warranty
- Specifications
- Power Supply Setup
- Torch Setup
- Operation
- Controls and indicators
- Operate the plasma system
- What to expect during and after cutting
- Understand duty-cycle limitations
- System operation guidelines
- Hand torch operation
- Troubleshooting and System Tests
- Theory of operation
- Troubleshooting preparation
- Power supply overview
- Troubleshooting guide
- Control board LEDs
- System tests
- Test 1 – voltage input
- Test 2 – power board voltage checks
- Test 3 – VBUS and voltage balance on power board
- Test 4 – solenoid valve
- Test 5 – torch stuck open or torch stuck closed
- Test 6 – plasma start
- Test 7 – torch cap-sensor
- Test 8 – fan
- Test 9 – internal compressor, compressor-driver board, and power board
- Power Supply Component Replacement
- Replace the power supply cover
- Replace the component barrier
- Detach and reattach the front panel
- Detach and reattach the rear panel
- Replace the power cord and strain relief
- Replace the power switch
- Replace the control board
- Replace the compressor-driver board
- Replace the power board
- Replace the drain hose, gas supply hoses, and 90° fitting
- Replace the wire group
- Replace the solenoid valve
- Replace the torch lead and strain relief
- Replace the air filter assembly
- Replace the air filter bowl and air filter element
- Replace the fan
- Replace the heat exchange coil
- Replace the internal compressor
- Replace the air inlet filter in the internal compressor
- Replace the front panel
- Replace the rear panel
- Replace the base
- Replace the magnetics assembly
- Replace the work lead and ground clamp
- Torch Component Replacement
- Parts
- Wiring Diagrams