Installation, 6 checking the installation, 7 linking automower™ to the loop generator/charger – Husqvarna 210 C User Manual
Page 26
English - 27
3. INSTALLATION
3.6 Checking the installation
Check the loop signal by looking to see what
indication the green LED on the loop
generator/charger is giving.
•
Steady light = the signal is okay.
•
Flashing once every other second = break in the
loop and no signal found.
•
Flashing twice every other second = weak
signal. This may be due to the boundary wire
exceeding 250 metres or that the cable is
damaged. If the mower works, it is not a
problem.
3.7 Linking Automower™ to the loop
generator/charger
1.
Connect the loop generator/charger charging
cable to the mower's charger contact. At most
the mower may be two metres from the working
area's boundary wire and the loop
generator/charger must be connected to the
mains supply.
2.
Open the control panel cover by pressing the
STOP button. Set the main switch to the ON
position.
3.
The yellow indicator lamp PIN code should now
flash.
4.
Select and enter a four digit PIN code. All
combinations except 0000 are permitted.
5.
Press the YES button.
6.
Confirm the selected PIN code by re-entering the
PIN code.
7.
Press the YES button.
8.
The yellow indicator lamp PIN code flashes
once, and then remains unlit.
When you have selected a PIN code, the mower and
loop generator/charger are linked to each other and
the mower can be operated.
3012-773
3012-758
3012-797
2 m
3012-785