Husqvarna 210 C - Manual (Page 20)

English - 21
3. INSTALLATION
Boundaries within the working area
Use the boundary wire to demarcate areas inside the
working area by creating islands around obstacles
that can not withstand a collision, for example, flower
beds and fountains. Run the cable out to the area,
route it around the area to be demarcated and then
back along the same route. If staples are used, the
wire should be laid under the same staple on the
return route. When the boundary wire to and from the
island are close together, the mower can drive over
the wire.
Obstacles that can withstand a collision, for example,
trees or bushes higher than 15 cm, do not need to be
demarcated by the boundary wire. Automower will turn
when it collides with this type of obstacle.
However, for the most gentle and silent operation, it is
preferable to demarcate all fixed objects in and around
the working area.
Obstacles that slope slightly, for example, stones or
large trees with raised roots, should be demarcated
or removed. Automower can otherwise slide up onto
this kind of obstacle causing the blades to be
damaged.
If the mowing result in the garden is uneven due to
the shape of the garden, for example because of a
long passage, you have the option of dividing up your
garden into zones. This is done with the help of the
boundary wire, see the figure on the right. When the
mower is placed in zone 1, it will not mow in zone 2
and vice versa Move the mower between the zones
to maintain an even mowing results. Also see 6.
Garden example - proposed installation and settings
page 34.
3012-764
3012-765
3012-787
30 cm
Zone 1
Zone 2