Husqvarna 210 C - Manual (Page 24)

English - 25
3. INSTALLATION
Joining the boundary wire
If the boundary wire is not long enough and needs to
be spliced: Use original solderless coupler. It is
waterproof and gives a reliable electrical connection.
To splice: Insert both cable ends in the coupler. Now
press down the button on top of the connector fully.
Use a pair of pliers or the like, as the button on the
connector is difficult to press down by hand.
IMPORTANT INFORMATION
Pay particular attention not to cross the
boundary wire in towards the loop
generator/charger.
IMPORTANT INFORMATION
Twisted cables, or a screw terminal
(chock-block), insulated with insulation tape
is not a satisfactory splice. Soil moisture will
cause the conductors to oxidise and after a
while result in a broken circuit.
3012-535
3012-536