Installation, 5 connecting the boundary wire – Husqvarna 210 C User Manual
Page 25
26 - English
3. INSTALLATION
3.5 Connecting the boundary wire
Connect the boundary wire to the loop
generator/charger:
1.
Place the cable ends in the connector:
• Open the connector.
• Place the wire in the connector grip.
2.
Press the connector together using a pair of
pliers. Press until you hear a click.
3.
Cut off any surplus boundary wire. Cut 1 - 2 cm
above respective connectors.
4.
Attach the connector to the contact pin on the
loop generator/charger.
3012-284
3012-264
3012-265
3012-771
See also other documents in the category Husqvarna Gardening equipment:
- 128LD (71 pages)
- 125B (47 pages)
- HEDGE TRIMMER ATTACHMENT (32 pages)
- 2754 GLS (49 pages)
- 532424761R1 (48 pages)
- 650CRT (28 pages)
- 1200-18 (68 pages)
- 324LD (32 pages)
- 324LD (28 pages)
- Hedge Trimmer 123HD65X (24 pages)
- 96045000410 (45 pages)
- 325L (36 pages)
- 966582101 (56 pages)
- 7021CP (18 pages)
- 11 (56 pages)
- 325HE4 x-series (24 pages)
- 323HE3 (24 pages)
- 325HDA65X-Series (24 pages)
- 326HD60 (24 pages)
- 5521RS (22 pages)
- Viking CA 150 (12 pages)
- 20 ProFlex (48 pages)
- 70 LP (8 pages)
- 326ES (32 pages)
- 250R (48 pages)
- 232L (32 pages)
- 227L/LD (32 pages)
- 965921501 (76 pages)
- 250 R (52 pages)
- 7021F (21 pages)
- 965969401 (8 pages)
- 210 C (50 pages)
- 966614401 (72 pages)
- 6022SH (18 pages)
- DRT 900 DRT 900 (29 pages)
- 142 RB (29 pages)
- 380 (9 pages)
- 96143005700 (18 pages)
- T 50RS (21 pages)
- 1200 (40 pages)
- 1200 (35 pages)
- H342SG (10 pages)
- 326R (36 pages)
- 125LDx (23 pages)