Hearth and Home Technologies 3500P - Manual (Page 5)

5
Importance of adequate fresh Combustion Air
Every home is a slightly different situation and depending on the design of the air movement within the
home, might be easy to distribute heat or very difficult. If you have boiler heat or other non-ducted
central heating this becomes even more of a challenge as adequate circulation within the home and proper
make up air for combustion is lacking because of the design of your central heating system.
When a forced-air system is put into a home that is not designed with proper circulatory patterns, it might
be necessary to add return air ducts or at least vents to get the air moving around the home. Fresh air for
the home and fresh air for combustion will have to be added or the stove or furnace will burn dirty and
efficiency will suffer.
Your dealer needs to assess the fresh air requirements for the home. At a minimum, there should be a 6”
or larger (this should be determined by figuring what the home requires) fresh air vent coming in to a
neutral part of the home to make sure that there is adequate fresh air to the home. Then the 3”make up air
to the unit is required to be provided. This must be done on every installation.
If the (fuel) corn is not burning correctly you need to address a few things. Is the corn wet or dirty? If it
is, make sure that your corn is cleaned and below 15 percent moisture. 11-12 percent moisture is ideal.
Also make sure that your appliance is installed, venting and operating properly.
The most common cause of corn not burning properly is contaminated air or negative pressure in the
home. It can be as simple as the air adjustment not set properly on the side of the stove or it could be that
there is a serious lacking of good quality air in the home caused by negative pressure. If you have done
any remodeling or if this is a newer home, it is a very real possibility that this is happening. Most
basements have negative pressure even if you feel that your home is drafty. This is called the stack or
chimney effect. This is the number one cause of a unit not performing properly.
If there is a black coating of soot coming into the home it is caused by the reversal of the exhaust that
would normally exit the stove outside being drawn into the home by negative pressure or improperly
installed venting. Depending on your venting configuration this could be aggravated by back drafts, high
wind and cold chimneys. This is a serious issue. Consult your dealer or installer immediately.
Sometimes this also occurs if there is an intake for fresh air too close to the exhaust on the outside of the
home or other conditions causing the exhaust to be pulled back into the home.
The first indications of negative pressure affecting the stove occurs app. 3 days after the stove is lit. The
glass gets dirty very easy, the firepot might keep filling up even though you pull the air adjustment out,
and you notice that the venting fills up with soot rapidly. After a few days, the exhaust can no longer
adequately pull out all of the fly ash so it reverses and is pulled into the home. This might happen
through the venting if it is not sealed properly or it might come out when you open the door for
maintenance and also backwards through the air wash system.
This can be easily corrected by adding the fresh air for the home and also for the appliance. It is
imperative that you would have your dealer or installer check the unit out for proper operation to make
sure that there is nothing mechanical wrong with the appliance and then determine your need for proper
fresh air. Your dealer can contact the factory with any questions that he might have.