Hearth and Home Technologies 3500P - Manual (Page 21)

FIREPLACE INSERT INSTALLATION REQUIREMENTS
The MagnuM Countryside Model 3502 Fireplace Insert may be installed in a masonry factory built
fireplace or on a non-combustible floor as shown below. NOTE: When installing as a fireplace insert,
the unit must extend out of the fireplace opening 12” to accommodate access to the circuit board panel,
draft slide (located on the left side of the insert) and the top front hopper lid (to fill the hopper with fuel).
CAUTION
21
There are serious consequences for using makeshift compromises during installation.
Always use proper listed materials. Do not cut corners. Serious complications and
possible safety risks may occur. Always use a certified installer.
NOTE: The circulation air inlet fins must be inside the room. Do not put the shroud in front of them.
NOTE: Existing fireplace dampers must be locked in the open position, seal any openings between the
masonry of the fireplace and the facing masonry.
This installation is
not recommended