Hearth and Home Technologies 3500P - Manual (Page 39)

39
SETTING THE CIRCUIT BOARD
If the low fire heat setting is too low for the fuel that
the draft setting is too low on the number 1 or 2-heat
o adjust the settings, place a small screwdriver
he systems indicator light will blink showing the
ote: Number 1 on the draft adjustment
HESE SETTINGS NEED TO BE MADE
he circuit board fuse is located on the back of the
located on the back of the
you are burning and the fire goes out, the number 1 or
2 heat setting can be adjusted through the access hole
located next to the system indicator light. (2)
If
setting, it can be adjusted through the access hole
located next to the fuel stirrer knob. (1)
T
through the hole to the adjustment screws. Turning the
screw clockwise increases the draft and
counterclockwise decreases the draft. (1) Turning the
screw clockwise decreases the fuel feed rate and
counterclockwise increases the fuel feed rate. (2)
T
number that you are on. There are 10 settings that are
available with 1 blink being the lowest and 10 blinks
being the highest. When you turn the adjustment
screw to the next setting the light will blink the number
that you are on and then the light will stay on.
(Example: If the setting is turned to # 9 the light will
blink 9 times and then stay on).
N
setting is the
Draft Adjustment
lowest setting and on the Fuel Feed rate adjustment
setting it is the highest feed rate. As you turn the
adjustment screw clockwise 1 – 2 – 3, etc the draft (1)
will increase and the fuel feed rate (2) will decrease.
The normal settings on both should be 1 blinks
T
BY A QUALIFIED COUNTRYSIDE
SERVICE TECHNICIAN.
Fuel Feed Rate Adjustment
T
board. If the board does not work, check the fuse to
make sure that it is good.
The thermostat hookup is
circuit board. See thermostat installation.