HP 32SII - Manual (Page 343)

Messages E–3
File name 32sii-Manual-E-0424
Printed Date : 2003/4/24 Size : 17.7 x 25.2 cm
% !! Attempted to refer to a nonexistent program label (or
line number) with
U , U Π, W , or { }.
Note that the error % !! can mean
you explicitly (from the keyboard) called a
program label that does not exist; or
the program that you called referred to another
label, which does not exist.
The catalog of programs ( z X { } )
indicates no program labels stored.
! SOLVE cannot find the root of the equation using the
current initial guesses (see page C–8). A SOLVE
operation executed in a program does not produce
this error; the same condition causes it instead to skip
the next program line (the line following the
instruction
# variable).
#$ Warning (displayed momentarily); the magnitude of
a result is too large for the calculator to handle. The
calculator returns ±9.99999999999E499 in the
current display format. (See "Range of Numbers and
Overflow" on page 1–12.) This condition sets flag 6.
If flag 5 is set, overflow has the added effect of
halting a running program and leaving the message
in the display until you press a key.
! Indicates the "top" of program memory. The memory
scheme is circular, so
! is also the "line"
after the last line in program memory.
" The calculator is running a program (other than a
SOLVE or
∫ FN routine).
! Attempted to execute # variable or ∫ d
variable without a selected program label. This can
happen only the first time that you use SOLVE or
∫ FN
after the message & , or it can happen
if the current label no longer exists.
# !# A running program attempted to select a program
label (
/ label) while a SOLVE operation was
running.
#1 #2 A running program attempted to solve a program
while a SOLVE operation was running.
#1
∫
2 A running program attempted to integrate a program