Honeywell PRESTIGE THX9000 User Manual
Page 10
Prestige
TM
Installation Guide
10
69-2057EFS—03
Link remote control to thermostat (optional)
Link outdoor sensor to thermostat (optional)
1 Make sure the thermostat displays
the “Add Device” timer (see page 9).
2 Press CONNECT at the remote. There
will be a short delay as the remote
seeks a signal from the thermostat.
3 When the screen displays
"Connected," press
DONE.
4 Press NO at the next screen to save
and exit. (Or press
YES and repeat
steps 1-4 to link another thermostat.)
1 Make sure the thermostat displays
the “Add Device” timer (see page 9).
2 Press the CONNECT button on the
back of the sensor.
3 Check thermostat to verify that the
outdoor sensor is working. After
about 15 seconds, the thermostat
should display outdoor temperature
and humidity.
Press to link to
another thermostat
Press to save
and exit
Press and release
The linking procedure at the remote may time
out if there is no keypress within 30 minutes.
To begin again, press and hold the blank
space (or arrow, if present) in the lower right
corner of the screen until the display changes
(about 3 seconds).
CONNECT
WIRELESS SETUP
MCR28805
NO
YES
CONNECT MORE?
MCR28806
MCR28846
MCR28847