HP C6734A - Manual (Page 26)

22 Chapter 5—Load paper or transparency film, or load originals
HP OfficeJet G Series
To use the ADF
1
Lift the lid, and make sure that the glass is clean.
For more information, see “Clean the glass” in the OnScreen Guide.
2 Close the lid.
3 Place all originals in the legal-size tray with the printed side facing toward the back
and with the top of the document pointing down.
4 Align the paper with the left side of the legal-size tray.
When working with originals that were originally loaded in the ADF in vertical
orientation, you may notice during processing that part of the original temporarily
sticks out from under the lid and a short delay occurs. This is normal behavior.
Avoid paper jams
To avoid paper jams, remove papers from the output tray frequently. Output tray
capacity is affected by the type of paper and the amount of ink you are using. For more
information about output-tray capacity, see “Technical information.” For help with
clearing a paper jam, see the Troubleshooting Help available through the Director.
Insert legal-size or mix of
legal- and letter-size
originals vertically.
AvMac.book Page 22 Friday, June 23, 2000 10:34 AM