HP C6734A User Manual
Page 18
14
Chapter 5Load paper or transparency film, or load originals
HP OfficeJet G Series
Load the input tray with letter-, legal-, or A4-size paper
For best results, adjust the paper settings each time you change paper types. For more
information, see Set the paper type.
1
Pull out the bottom (input) tray, and slide the paper-width and -length adjusters to
their outermost positions.
2
Tap the stack on a flat surface to even the edges of the paper, and then check the
paper for the following:
Make sure it is free of rips, dust, wrinkles, and curled or bent edges.
Make sure all the paper in the stack is the same size and type, unless you are
working with photo paper.
3
Insert paper into the input tray, print-side down and letterhead or top of page first,
until it stops.
4
Slide the paper-width and -length adjusters in until they stop at the edges of the
paper, and be sure that the paper stack lies flat in the input tray and fits under the
tab of the paper-length adjuster.
AvMac.book Page 14 Friday, June 23, 2000 10:34 AM