Havis-Shields P-MFK-5 - Manual (Page 2)

P-MID-1^MFK-5_INST_9-07
SUB ASSEMBLY:
1. Remove “C” pillar trim panel. This is necessary for driver side mounting bracket.
2. Position upper center filler to partition and mark mounting holes.
3. Drill 5/16” holes on marks.
Always
!
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
INSTALLATION:
1. ATTACH PARTITION TO FLOOR:
• Place partition carefully into vehicle behind the first
row bench.
• Move bottom of partition forward to the back of seat
base on first row bench.
Note: Driver side mounting leg on partition will be forward of seat belt
hold down on floor of van.
• Pre-drill the (3) driver side mounting leg holes with
3/16” drill bit. Be sure to check for obstructions.
• Attach partition to van floor at driver side mounting leg
using (3) ¼” x 1 ½” Hex head lag bolts.
• Proceed to partitions passenger side mounting leg. Be
sure to check that partition is square with the bench seat.
• Pre-drill the (2) passenger side mounting leg holes with
3/16” drill bit. Be sure to check for obstructions.
• Attach partition to van floor at passenger side mounting
leg using (2) ¼” x 1 ½” Hex head lag bolts. Partition is
now self-supporting.
2. ATTACH (2- PIECE) DRIVER SIDE
“B” PILLAR MOUNTING BRACKET:
• Hold 2-piece driver side mounting
bracket to partition and “C-pillar”
of van.
• Determine proper location to
mount 2-piece bracket to partition.
• Drill (2) 5/16” holes where
mounting bracket and partition
meet.
• Attach bracket to partition using
¼-20 x ¾” Carriage bolts and
¼” x 1 ½” Hex Head Lag Bolts