Hitachi CMP307XU - Manual (Page 26)

24
ENGLISH
OTHERFEATURES (continued)
1) The video signal when a screen with an aspect ratio (the ratio between the sides and width
of the screen) of 16: 9 is compressed to 4: 3.
* indicates signals and indicates screens in the chart above
●The display method can be switched by changing the settings of the display area (when the RGB input
jack is selected) or display size (when the Video input jack is selected).
Input signal ( )
(Resolution)
Display area setting (DISPLAY AREA)
NORMAL (normal number of pixels) FULL (expanded number of pixels)
640 x 400 640 x 400
1024 x 768 1)
640 x 480 640 x 480
800 x 600 800 x 600
832 x 624 832 x 624
1024 x 768 1024 x 768
1280 x 1024 1024 x 768 2) (Squeezed display, partial display)
1) The expanded processing method ( INTERPOLATION) becomes effective.
2) The display status and display area is changed each time the SELECT button is pressed, or
each time the
or keys of the remote control are pressed. (Refer to Display Area)
Display may not be correct in some cases, depending on the signal conditions.
Switching when the RGB input jack is selected
Switching when the Video Input jack is selected
Problem
This setting is used
normally.
When it is desired to
slightly enlarge images
when black stripes
appear at the top and
bottom of the screen.
When it is desired to
view a Squeeze signal
image. When it is desired to
slightly enlarge a
Squeeze signal image.
Display size setting
(DISPLAY SIZE)
NORMAL WIDE SQ.N SQ.W
Input signal
Display screen
Remarks
All four edges of the
screen are missing.
Adjust the horizontal
and vertical positions
when text is
missing.
The left and right side
of the screen are
missing.
Adjust the horizontal
position when text
is missing.
Squeez signal 1)
Normal display Enlarge the entirety Vertical compression Enlarge horizontally
19
30
20
19
4:3 signal 4:3 signal
19
HINTS
To maximize display performance, it is recommended that the 1024 x
768 (vertical frequency 60Hz) input signal specifications be used.
Switching the Display Method