Hitachi CMP307XU - Manual (Page 15)

13
ENGLISH
When the indicating lamp blinks in green or the message “POWER
SAVE” or “OUT OF FREQUENCY” appears on the screen, there is
something unusual about the status of reception. See “Symptoms
That Seemingly Appear to be Failures.”
OPERATING INSTRUCTIONS
To turn on the set power supply, set the MAIN POWER switch ( ) of the main unit to ON and
then press the SUB POWER button ( ) or the POWER button of the remote control.
To turn off the set power supply, press the SUB POWER button ( ) of the main unit or the
POWER button of the remote control, then set the MAIN POWER switch ( ) to OFF.
For normal operations, leave the main power switch ( ) set to ON and use the sub power button or
the Power button of the remote control to turn the power on and off.
The indicating lamp lights when the power is turned on.
TIPS
Avoid repeatedly turning the monitor on and off at short time intervals.
Failures might result from such operation.
Turn off the main power switch ( ) before leaving the monitor out of
use for an extended period of time.
If a power failure occurs while the set is running, it would be powered
on upon recovery from the failure. Turn off the unit main power switch
before leaving the set.
26
Indicating lamp Power status
Lit in red OFF
Lit or flickering in green ON
POWER
Main power
switch
Set unit Remote
controller
Turning Power On and Off