Hearth and Home Technologies Santa Fe Pellet Insert SANTAFEI-B - Manual (Page 5)

R
September 1, 2008 7019-205C Page 5
Santa Fe Pellet Insert
2
Getting Started
A. Design, Installation & Location Considerations
Damaged parts could impair safe
operation. Do NOT install damaged, incomplete or substitute
components.
1. Appliance Location
OT Check building codes prior to installation.
• Installation MUST comply with local, regional, state and
national codes and regulations.
• Consult insurance carrier, local building inspector, fire
officials or authorities having jurisdiction over restrictions,
installation inspection and permits.
It is a good idea to plan your installation on paper, using
exact measurements for clearances and floor protection,
before actually beginning the installation
Consideration must be given to:
• Safety, convenience, traffic flow
• Placement of the chimney and chimney connector.
• If you are not using an existing chimney, place the appli-
ance where there will be a clear passage for a factory-
built listed chimney through the ceiling and roof.
• Installing an optional outside air kit would affect the loca-
tion of the vent termination.
T O If burning shelled field corn, you must use ap-
proved venting specifically designed for corn to prevent corro-
sion or degradation. Follow the instructions from the venting
manufacturer.
Since pellet exhaust can contain ash, soot or sparks, you
must consider the location of:
• Windows
• Air Intakes
• Air Conditioner
• Overhang, soffits, porch roofs, adjacent walls
• Landscaping, vegetation
When locating vent and venting termination, vent above
roof line when possible.
Marginal Location:
Below peak
Location NOT recommended:
Not the highest point of the roof
Wind loading possible
Multi-level Roofs
Windward
Leeward
Recommended:
Outside Air Intake
on windward side NOT recommended:
Outside Air Intake
on leeward side
Recommended Location:
Above peak
Recommended:
Insulated exterior chase
in cooler climates
Recommended Location:
Above peak
Inside heated space
Location NOT recommended:
Too close to tree
Below ad acent structure
Lower roof line
Avoid outside wall
Marginal Location:
Wind loading possible
OT Locating the appliance in a location of
considerable air movement can cause intermittent smoke
spillage from appliance. Do not locate appliance near:
• Frequently open doors
• Central heat outlets or returns
Figure 5.1