Hearth and Home Technologies Santa Fe Pellet Insert SANTAFEI-B - Manual (Page 2)

Page 2 7019-205C September 1, 2008
R Santa Fe Pellet Insert
and Welcome to the Quadra-Fire Family
!
Hearth & Home Technologies welcomes you to our tradi-
tion of excellence! In choosing a Quadra-Fire appliance,
you have our assurance of commitment to quality, durabil-
ity, and performance.
This commitment begins with our research of the market,
including ‘Voice of the Customer’ contacts, ensuring we
make products that will satisfy your needs. Our Research
and Development facility then employs the world’s most
advanced technology to achieve the optimum operation of
our stoves, inserts and fireplaces. And yet we are old-fash-
ioned when it comes to craftsmanship. Each unit is meticu-
lously fabricated and surfaces are hand-finished for lasting
beauty and enjoyment. Our pledge to quality is completed
as each model undergoes a quality control inspection.
We wish you and your family many years of enjoyment in
the warmth and comfort of your hearth appliance. Thank
you for choosing Quadra-Fire.
SAMPLE:
SERIAL NUMBER LABEL
LOCATION:
Behind left access panel.
U.S. ENVIRONMENTAL PROTECTION AGENCY
This model is exempt from EPA certification under 40 CFR
60.531 by definition [Wood Heater (A) "Air-to-Fuel Ratio"].
7019-204B
SANTA FE PELLET INSERT
R
SERIAL NO. / NUMÉRO DE SÉRIE
DO NOT REMOVE THIS LABEL / NE PAS ENLEVER L'ÉTIQUETTE
JAN FEB MAR APR MAY JUNE
2008 2009 2010
JULY AUG SEPT OCT NOV DEC
Report / Rapport: 061-S-62-6
Made in China/ Fait Aux Chine
B
b
b
S
007008
O-T L Tested and
Listed by
Portland
Oregon USA
OMNI-Test Laboratories, Inc.
C US
Re ort No.
#061-S-62-6
7019-209
O-T L Tested and
Listed by
Bea erton
Oregon USA
OMNI-Test Laboratories, Inc.
C US
SAFETY LABEL
R
Santa Fe Pellet Insert
1445 Highway North, Colville, WA 99114
Manufactured by:
www. uadrafire.com
Listed Solid Fuel Room Heater/Pellet Type Insert. Also suitable for Mobile Home Installation. This
appliance has been tested and listed for use in Manufactured Homes in accordance with OAR
814-23-9000 through 814-23-909.
Tested to: ASTM E-1509-2004, ULC S628-93, ULC /ORD-C1482-M1990 Room Heating Pellet Burning
Type, (UM) 84-HUD FOR USE ONL WITH PELLETI ED WOOD OR SHELLED FIELD CORN FUEL.
Route power cord away from unit. Do not route cord under or in front of appliance.
DANGER Risk of electrical shock. Disconnect power supply before servicing. Replace glass only with
5mm ceramic available from your dealer.
To start, set thermostat above room temperature, the appliance will light automatically. To shutdown, set
thermostat to below room temperature. For further instruction refer to owner s manual.
eep viewing and ash removal doors tightly closed during operation.
PREVENT HOUSE FIRES
Install and use only in accordance with manufacturer s installation and operating instructions. Contact
local building or fire officials about restrictions and inspection in your area.
ARNING - FOR MOBILE HOMES Do not install appliance in a sleeping room. An outside
combustion air inlet must be provided. The structural integrity of the mobile home floor, ceiling and
walls must be maintained.
Refer to manufacturer s instructions and local codes for precautions re uired for passing chimney
through a combustible wall or ceiling. Inspect and clean vent system fre uently in accordance with
manufacturer s instructions.
Do Not Connect This Unit to a Chimney Serving Another Appliance.
Use a 3" or 4" diameter type "L" or "PL" venting system.
Input Rating: 30,000 BTU/HR.
Electrical Rating: 115 AC, 60 Hz, Start 4.1 Amps, Run 1.1 AMPS.
MINIMUM CLEARANCES TO COMBUSTIBLE MATERIALS
AS A BUILT-IN UNIT
A Top of Hopper Top ent 2.0 in. 51mm
Rear ent 2.5 in. 64mm
B Side of Hopper Top/Rear ent 2.0 in. 51mm
C Back of Hopper Top/Rear ent 2.5 in. 64mm
D ent Pipe to Combustible Top/Rear ent 3.0 in. 76mm
A
C
B
D C
B
0 in. Clearance To Exposed Section And Face Trim
Masonry or ero Clearance
Max. Mantel Depth: 12 in. (305mm)
SIDE W
ALL
MANTEL
B
D A
E F
Face Trim
C
DO NOT REMOVE THIS LABEL
A Insert side to combustible side wall 16 in. 406mm
B Insert top to mantel 12 in. 305mm
C Insert top to max. 2.25 in. to top face trim 4.75 in. 121mm
D Insert side to max. 2.25 in. to side face trim 10 in. 254mm
E Hearth extension to from door opening - front 6 in. 152mm
F Hearth extension from side of door opening 6 in. 152mm
SAMPLE: CLEARANCE TO COMBUSTIBLES LABEL
LOCATION: On chain behind right access panel
S
A
M
P
L
E
S
A
M
P
L
E