HANNspree DT0B-10A1 - Manual (Page 28)

27
Switching Source Signals
Press the SOURCE button on the
remote control or the SOURCE
button on the control panel to
select the incoming source sig-
nal.
The current source setting CH xx
appears on the top left corner of
the screen, AV1 or AV2 appears
on the bottom right corner of the
screen.
Note:
The TV supports S-Video input in
addition to normal video and audio signals. The TV detects the signal type
automatically and gives priority to S-video when two signals are detected
at the same time. This auto detection function is only available for AV2.
Adjusting the Volume
Press the VOL UP button to
increase the volume. Press the
VOL DOWN button to decrease
the volume. The volume level is
displayed on the TV.
Press the MUTE button on the
remote control to turn the sound
off. The word “Mute” appears on
the top left corner of the screen
and sound is temporarily turned
off.
Press the MUTE button on the
remote contorl or press the VOL UP button or VOL DOWN button to
restore the original volume.
MENU SOURCE
CH CH
V
V
C H 4 0
A V 1
TV/AV
Current source setting
Source
MENU SOURCE
CH CH
V
V
Volume up
Volume down
Mute