HP Photosmart E327 - Manual (Page 26)

26 HP Photosmart E327 User Guide
Setting the flash
The Flash button allows you to cycle through the flash
settings on the camera. To change the flash setting, press the
Flash button until the desired setting appears on the Image
Display. The following table describes each of the flash
settings on the camera.
NOTE: The flash is not available in Sunset mode nor is it
available while recording video clips.
If the flash setting is anything other than the default Auto
Flash setting, the icon for the setting will appear in the Live
View screen. The new setting remains in effect until it is
changed again or until the camera is turned off. The flash
setting resets to the default Auto Flash setting when you turn
the camera off.
Setting Description
Auto
Flash
The camera measures the light level and uses the flash
if necessary.
Red-Eye The camera measures the light level and uses the flash
with red-eye reduction if necessary (for a description of
red-eye reduction, see Red eye on page 27).
Flash On The camera always uses flash. If the light is behind your
subject, you can use this setting to increase the light on
the front of your subject. This is called fill-flash.
Flash Off The camera will not use flash, no matter the lighting
conditions. Use this setting to capture poorly lit subjects
that are beyond the flash range. Exposure times may
be increased when using this setting, so you should use
a tripod to avoid blurry pictures from camera shake.