HP ELITE 8000 - Manual (Page 44)

10,000 RPM Serial ATA
Hard Drives 160 GB Capacity 160,041,885,696 bytes
Height 1 in (2.54 cm)
Width Media diameter: 3.0 in (7.62 cm)
Physical size: 4 in (10.2 cm)
Interface Serial ATA (1.5 Gb/s), Native Command Queuing
enabled
Synchronous Transfer
Rate (Maximum) Up to 3.0 Gb/s
Cache 16 Mbytes
Seek Time (typical
reads, includes
controller overhead,
including settling) Single Track 0.3 ms
Average 4.6 ms
Full-Stroke 10.2 ms
Rotational Speed 10,000 rpm
Logical Blocks 312,581,808
Operating
Temperature 41° to 131° F (5° to 55° C)
Solid State Drive 64 GB Capacity 64 GB
NAND Flash Memory Multi Level Cell (MLC) with wear leveling controller
Interface type SATA 3Gb/sec
Dimensions-external
(W x H x D) 2.74 x 0.37 x 4 in (6.98 x 0.95 x 10.2 cm)
Weight 0.14 lb (65 g)
Internal transfer rate Write speed Up to 220 MB/s
Read speed Up to 120 MB/s
Host transfer rate Ultra DMA mode Up to 150 MB/s
Power DC power requirement 5 VDC 5%-100 mV ripple p-
p
Total power
consumption <1.12Watt
Environmental
(all conditions, non-
condensing) Temperature
(operating) 32° to 158° F (0° to 70° C)
Relative Humidity
(operating) 5% to 95%
Maximum Wet Bulb
Temperature
(operating) 84° F (29° C)
Regulations UL, CSA, EN 60950-2000, CISPR Pub 22 Class B,
CNS 13438, AS/NZS CISPR 22:2002 Class B, R1113
and C1172 Class B
NOTE: For solid state disk drives, GB means 1 billion bytes. 16GB is the
unformatted capacity of this drive before a portion of the drive is reserved for
flash management features. Actual capacity varies by content and will be less
than 15.8GB.
QuickSpecs
HP Compaq 8000 Elite PC
Technical Specifications - Hard Drives
DA - 13424 Worldwide QuickSpecs — Version 17 — 6/25/2010 Page 44