Installation, Precautions, Preparing to install the hardware – HP T2200 User Manual
Page 12: Required tools, Selecting a site
Installation 12
Installation
Precautions
Save these instructions. This document contains important safety instructions that should be followed
during installation, operation, and maintenance of the UPS and batteries.
WARNING:
A risk of personal injury from electric shock and hazardous energy levels exists.
The installation of options and routine maintenance and service of this product must be
performed by individuals who are knowledgeable about the procedures, precautions, and
hazards associated with AC power products.
WARNING:
To prevent personal injury from earth conductor leakage current:
•
Do not operate the UPS while disconnected from the utility power source.
•
Disconnect load devices before disconnecting the UPS from the utility power source.
WARNING:
To prevent personal injury, prepare the area and observe all materials handling
procedures when transporting the UPS. When fully assembled, the UPS weighs 29 kg (64 lb).
WARNING:
To prevent personal injury, prepare the area and observe all materials handling
procedures when transporting the ERM. When fully assembled, the ERM weighs 28.6 kg (63
lb).
Preparing to install the hardware
Before installing the hardware:
1.
Be sure the necessary tools and materials ("
2.
Select an installation site ("
3.
Prepare the equipment ("
" on page
) for installation in the rack.
Required tools
•
No. 2 Phillips screwdriver
•
T-20 Torx screwdriver
Selecting a site
WARNING:
To prevent fire or electric shock, install the unit in a temperature- and humidity-
controlled indoor environment, free of conductive contaminants.
When selecting a site, consider the following factors: