HP BH3710 - Manual (Page 55)

55
I. Establishing a Remote GUI Session
The Microsoft Windows 2000 operating system is loaded. Next, set up a remote
Graphical User Interface (GUI) so the blade server can be controlled remotely. Two
methods are discussed here. The first method is using Terminal Services and the second
method is using Symantec’s pcAnywhere software.
Terminal Services Installation Overview
Terminal Services provides access to Windows-based applications for a variety of client
hardware devices. Applications are installed on the server and accessed by clients
through terminal emulation.
Requirements
•
Microsoft Windows 2000 Advance Server
•
Microsoft Windows 2000 Server
•
Microsoft Windows 2000 Advance Server or Server CD
•
External USB Floppy Drive (Imation: FD-05PUB)
•
External USB CD-Rom Drive (Sony: CRX85U)
• Two (2) blank 3.5" floppy disk
NOTE Instructions are intended for the hp server bc1100 blade. USB
floppy and USB CD-ROM drives are not required, if the machine
has internal floppy and CD-ROM drives.
The setup process is the same for both Microsoft Windows 2000 Server and Microsoft
Windows 2000 Advance Server.
Server Setup
The server must have Terminal Services installed. To install, login as "Administrator"
and perform these steps.
1. Click Start | Settings | Control Panel Double click the Add/Remove Programs
icon.
2. Click on "Add/Remove Windows Components" on the left
3. Scroll down, check the "Terminal Services" box . Click Next.
4. Select "Remote Administration Mode" Click Next.
5. Connect the USB CD-Rom Drive. Insert the Microsoft Windows CD. Select the
"I386" directory. Open. Click OK.
6. When the installation is completed, click Finish to reboot.