HP BH3710 - Manual (Page 11)

11
A. Install the Microsoft Windows 2000 Advanced Server to Create a RIS and
DHCP Server
Booting the System
Boot the system using the Microsoft Windows 2000 Advanced Server CD. You will
see a message that reads, "Setup is inspecting your hardware configuration." Then
the setup screen will be displayed.
Installing Drivers
1. If you do not have additional drivers to add, skip to Continue the Installation below.
Otherwise: press F6 to add OEM SCSI, DAC when the message appears at the
bottom of the screen.
2. Press S to select additional hardware.
3. Select Other and press Enter.
4. If you have no other drivers that you need to install, press Enter to continue with the
installation.
Continue the Installation
1. Press Enter to continue at the "Windows 2000 Server Setup. Setup Notification…"
screen.
2. Press Enter to continue at the "Windows 2000 Server Setup. Welcome to Setup…"
screen.
3. Press C to continue setup at the "Setup has determined that your computer's startup
hard disk is new…" prompt.
4. Press F8 to accept the licensing agreement.
Create a Partition
1. At the drives partitioning screen, select the target drive and create a 4GB partition.
Press C to create a drive and a partition. Type 4096 and press Enter at the Create
partition size prompt.
2. Select the target drive to be used to install Microsoft Windows 2000. Press Enter.
3. Select Format the partition using the NTFS file system and press Enter.
4. The installer will format and copy files to the hard drive. The system will then
reboot.
Personalize Your Software
1. Click Next to continue at the Setup Wizard first dialog box.