HP BH3710 User Manual

Page 44

Text mode
Original mode

H. Use RIS to install Microsoft Windows 2K Adv Server to the Blade
Server

1. Connect stand-alone RIS server to same network as the bc1100 is on. If possible,

disconnect all other systems from network. This will ensure that there are no possible
network conflicts. Connect a USB keyboard and mouse to the bh7800. Also connect
a VGA monitor to the bh7800.

2. Remove all mass storage devices from the blade server including the USB floppy

drive, the USB CD-ROM drive and any storage blades currently installed.

NOTE :

This process cannot be completed using the RMC text console
because the Microsoft Windows installation changes to a Graphical
User Interface (GUI) after the reboot. The text console is not a
GUI device. Thus, a local VGA monitor, USB keyboard and
mouse are required for these steps.

This manual is related to the following products:

BH3700 BH7800