HP VA 7400 - Manual (Page 34)

VA 7100/7400 Cluster Installation Guide
10/12/01 31
5 Node 1 (Primary Node) Configuration
Introduction
This chapter contains the step-by-step procedure for configuration of node 1, the primary node, of the VA 7100/7400
disk array in a dual-path cluster configuration.
Preliminary Operations
The following preliminary operations must be successfully completed before beginning the node 1 configuration
procedure.
1. Ensure that all requirements detailed in chapters 2 through 4 have been thoroughly reviewed and successfully
completed.
2. Ensure that configuration of the internal and external arrays has been completed.
Configuration Procedure
To configure node 1 of the cluster, proceed as follows:
1. Reboot node 1.
2. Configuration screen of the dedicated Ethernet interconnect (crossover or heartbeat) NIC for node 1 is shown
below. Enter only the IP address and Subnet mask values. For node 1 TCP/IP values, set IP address to
10.0.0.1
and Subnet mask to 255.0.0.0. Leave all other fields empty.