beautypg.com

Panel set and cast trim set, Panel and cast trim must be ordered separately, Panel and gold trim set – Hearth and Home Technologies 4100I-GD-B User Manual

Page 14: 4100-i act wood insert, Figure 14c figure 14d

background image

4100-I ACT WOOD INSERT

Page 14

September 1, 2008

R

250-7201E

pANEL SET and CAST TRIM SET

1. Remove contents from box being careful not to scratch or damage cast trim pieces.

2. Lay the panel set face down on protective covering to prevent scratching the painted surface.

. Secure panel set together with screws provided.

Figure 14A

4. Now bend the tabs down toward the backside of the panel set, on top piece and on each leg. Leave panel set face down.

5. Place the corresponding cast trim pieces (2 cast trim legs and 1 cast trim header) underneath panel set, also face down.

6. Place washer provided over tab and secure the trim and panel together with screw. Continue for all tabs.

7. Secure cast footers with screws.

NOTE: DO NOT PiCK UP ASSEMBlED UNiT BY CORNERS. iT iS TOO HEAVY AND MAY DAMAgE THE

PANElS. PiCK UP FROM CENTER.

8. Slide assembled panel and trim over top of the insert into place.

9. Secure panels to insert with 8-2 sheet metal screws through tabs on bottom lower inside corners on side panels.

Figure 13B.

Included in Panel Kit: (2) side panels, left and right; (1) panel top; (2) trim pieces; (1) trim top; (1) fastener package.

Included in Cast Trim Kit: (2) cast trim legs, left and right; (1) cast trim header; (2) cast trim footers, left and right.
Tools Needed: Powered Phillips Head Screw Driver

panel and Cast Trim must be ordered separately.

1. Screw side panels

to top panel

2. Bend tabs

. Install Cast Trim

Header

2. Bend tabs

Tab with screw hole to

secure panel to insert

Secure side panels to insert with screws

Figure 14A

Figure 14B

COMpLETED VIEW

STANDARD SIZE: 30-1/2” h x 44-3/4”w

LARGE SIZE: 34”h x 48”w

BASIC STANDARD SIZE: 30”h x 40”w

pANEL and GOLD TRIM SET

1. Repeat Steps 1 - above.

2. To assemble the trim, attach the 2 side trim pieces to the top trim at each corner using the “L” bracket

included in fasteners package.

Figure 14C

. Slide panel and trim over top of the insert and into position.

Tab with screw

hole to secure

panel to insert

Screw side

panels to top

panel

View of "L" Bracket

installed

Figure 14C

Figure 14D

This manual is related to the following products: