HP GRACO OR PRO TI1681A - Manual (Page 16)

Installation
16 309293J
Select a Fluid Nozzle and Air
Cap
The gun is supplied with Part No. 197266 Nozzle and
197477 Air Cap. If you require a different size, refer to
Table 1 and Table 2 , and instruction manual 309419, or
consult with your Graco distributor. See Air Cap/Nozzle
Replacement on page 42.
WARNING
Pressurized Equipment Hazard
To reduce the risk of an injury, follow the
Pressure Relief Procedure on page 20
before removing or installing a fluid nozzle
and/or air cap.
Table 1: Fluid Nozzles
Part No.
Size,
mm (in.)
Part No.
Size,
mm (in.)
197263 0.75 (.030) 197266 1.5 (.055)
197264 1.0 (.042) 197267 1.8 (.070)
197265 1.2 (.047) 197268 2.0 (.080)
Table 2: Air Caps
Part No.
Pattern Shape
and Length
in. (mm)
Recommended Fluids and
Production Rates
197477
Round end;
15-17 (381-432) Light to medium viscosity.
Medium to high production.
197478
Round end;
15-17 (381-432) Light to medium viscosity.
Low to medium production.
197479
Tapered end;
13-15 (330-381) Light to medium viscosity.
Medium to high production.
197480
Round end;
16-18 (406-457)
Medium to high viscosity
and high solids.
Low to medium production.
197481
Tapered end;
17-19 (432-483)
Medium to high viscosity
and high solids.
Medium to high production.
For use with 2.0 mm nozzle.