haier ESD402 - Manual (Page 9)

Serial Number: Version:00.00 Edition: Nov.-23-2005
Built-In Dishwasher Model: ESD400/ESD401/ESD402
Page 8 / 48
Electrical
It is the customer’s responsibility:
To contact a qualified electrician. To assure that the electrical installation is adequate and in conformance
will all national and local codes and ordinances.
You must have:
- 120-volt, 60Hz, AC-only, 15- or 20-amp.,fused electrical supply.
- COPPER WIRE ONLY.
We recommend:
- a time-delay fuse or circuit breaker.
- a separate circuit.
If direct wiring dishwasher
- Use flexible, armored or non-metallic sheathed, copper wire with grounding wire that
meets the wiring requirements for your home and local codes and ordinances.
- Use strain relief method provided with house wiring junction box or install a
U.L-listed/CSA-certified clamp connector to the house wiring junction box. If using
conduit, use a U.L-listed/CSA-certified conduit connector.
If connecting dishwasher with a power supply cord:
- Use a U.L. -listed, 16-gauge, three-conductor power supply cord that meets all local
codes and ordinances. Maximum length of the power supply cord is 6 feet (1.8m).
- a clamp connector to fit a 7/8” (2.2cm) diameter hole is required to secure power supply
cord to dishwasher terminal box.
- Power supply cord must plug into a mating three-prong, grounded outlet, located in the
cabinet next to the dishwasher opening. Outlet must meet all local codes and
ordinances.
Water
You must have:
- a hot water line with 20-120 PSI (138-862 KPa) water pressure.
- 120
°
F(49
°
C) water at dishwasher.
- 3/8”O.D.tubing with compression fitting or flexible stainless steel braided fill line (1/2”
minimum plastic tubing is optional but not recommended).
- a 90
°
elbow with 3/8”N.P.T. external pipe threads on one end.
Do not solder within 6”(15.2cm) from water inlet valve.