haier ESD402 - Manual (Page 32)

Serial Number: Version:00.00 Edition: Nov.-23-2005
Built-In Dishwasher Model: ESD400/ESD401/ESD402
Page 31 / 48
detergent.
NOTE: Use both sections for cycles with 2 washes. Use only the
main wash section for cycles with 1 wash, See the "Cycle
Selection Charts "for more details.
How much detergent to use
-Different brands of dishwasher detergent have different
amounts of phosphorous for softening water .If you have hard
water and use a detergent with a phosphorous content of less than 8.7%, you might need to use more detergent , or use a
detergent with a phosphorous content higher than 8.7%.
-The amount of detergent to use depends on the hardness of your water and the type of detergent .If you use too little,
dishes won't be clean . If you use too much in soft water glassware will etch.
10.3 Rinse Aid dispenser
Rinse aids prevent water from forming droplets that can dry as spots or
streaks . They also improve drying by allowing water to drain off of the
dishes during the final rinse by releasing a small amount of the rinse aid
into the rinse water. Your dishwasher is designed to use a liquid rinse aid.
Do not use a solid or bartype.
Filling the dispenser
The rinse aid dispenser holds 4.8 oz(145ml) of rinse aid. Under
normal conditions, this will last for about three months. Rinse aid is released
through an opening in the dispenser. You do not to wait until the dispenser is
empty to refilled it. Try to keep it full, but be careful not to overfill it.
1. Make sure the dishwasher door is fully open.
2. Open the dispenser by pushing the cover latch.
3. Add rinse aid until the indicator window looks full.
4. Clean up any spilled rinse aid with a damp cloth.
5. Close the cover.
Rinse aid setting
The amount of rinse aid released into the final wash can be adjusted .The factory setting is at
3. For most water conditions. Set the adjuster to 2 or 3.If there are rings or calcium (hard
water) spots on dishes, try a higher setting.
To adjust the setting
Open the dispenser cover. Turn the adjuster inside the dispenser to the desired setting.
10.4 Cycle Selection Charts