haier ESD402 - Manual (Page 10)

Serial Number: Version:00.00 Edition: Nov.-23-2005
Built-In Dishwasher Model: ESD400/ESD401/ESD402
Page 9 / 48
Drain
You must :
- Use the new drain hose supplied with your dishwasher. If this is not suitable, use
a new drain hose with a maximum length of 12 feet(3.7 m) that meets all current
AHAM/IAPMO test standards, is resistant to heat and detergent, and fits the drain
connector on your dishwasher.
- have a high drain loop 20 inches (50.8cm) above the subfloor or floor.
- connect drain hose to waste tee or disposer inlet above drain trap in house
plumbing and 20 inches (50.8cm) minimum above the floor.
- use an air gap if the drain hose is connected to house plumbing lower than 20
inches (50.8cm) above subfloor or floor.
- use 1/2” minimum I.D. drain line fittings.
Cut openings in shaded area of cabinet walls or floor as specified in chart:
*
Measured from the lowest point on the underside of
countertop. May be reduced to 33-7/8” (86cm) by
removing wheels from dishwasher.
* *
Minimum, measured from narrowest point of
opening.
* ** Maybe increased to 6-7/8”(17.5cm) if height of
opening is 34-1/2”(87.6cm)at lowest point.